Hello, had a question about forming 5 minute bar charts with the BW command. Let's say I send this input:
BW,AMD,300,20190920 150000,,,,160000,,s,,1
Where:
[Interval] is 300
[BeginDate BeginTime] is 20190920 150000
[EndFilterTime] is 160000
I noticed that the output is:
BH,AMD,2019-09-20 15:10:00,29.9916,30.0100,29.9603,29.9900,40499085,186030,0,
BH,AMD,2019-09-20 15:20:00,29.9910,30.0499,29.9850,30.0268,41155771,306028,0,
BH,AMD,2019-09-20 15:30:00,30.0401,30.0500,30.0100,30.0300,41785831,299608,0,
BH,AMD,2019-09-20 15:40:00,29.9700,29.9900,29.9600,29.9850,42484285,275326,0,
BH,AMD,2019-09-20 15:50:00,29.9700,29.9750,29.8600,29.8850,43546108,641482,0,
BH,AMD,2019-09-20 16:00:00,29.9900,30.0800,29.9750,30.0400,47936227,3503308,0,
The data is being sent back in increments of 10 minutes. E.g.
15:10:00, 15:20:00, 15:30:00, 15:40:00, ...
Shouldn't it instead be returning data in increments of 5 minutes since 300 was specified as the interval? E.g.
15:05:00, 15:10:00, 15:15:00, 15:20:00, 15:25:00, ...
Edited by keohir808 on Sep 20, 2019 at 04:50 PM